Voorbeelden van het gebruik van Dosing button in het Engels en hun vertalingen in het Nederlands
{-}
-
Medicine
-
Colloquial
-
Official
-
Ecclesiastic
-
Financial
-
Computer
-
Ecclesiastic
-
Official/political
-
Programming
Do not press the dosing button.
The dosing button must not be pressed.
Remember that only the patient may touch the dosing button.
Press the dosing button down slowly and firmly until the button can no longer move.
press and release the dosing button 2 times within 3 seconds.
The colour of the dosing button is different for each strength of the PegIntron pre-filled pen.
It is important that you keep the ViraferonPeg pre-filled pen upright(Dosing button down) as shown in figure 1.
A recessed on-demand dosing button and red light are located on the top housing of the IONSYS system.
Hold the PegIntron pre-filled pen with your fingers wrapped around the pen body barrel and your thumb on the dosing button figure 7.
Turn the dosing button until your prescribed dose is in line with the dosing tab.
over the light window, the digital display, or the dosing button.
This can be done by pressing the recessed dosing button of the IONSYS, with the IONSYS still in its sealed sachet.
a light window, and a dosing button.
If you have trouble dialing your dose, check to make sure the dosing button has been pulled out as far as it will go.
Keep the ViraferonPeg pre-filled pen UPRIGHT(Dosing button down) and keep both needle caps on until you are ready to inject.•
the patient should press and release the dosing button twice within 3 seconds.
Place the ViraferonPeg pre-filled pen upright in the holder of the tray provided in the pack(the dosing button will be on the bottom)
Place the pen back into the holder in the tray with the dosing button on the bottom.
Do not practice any pressure on the dose button during injection.
Do not put any pressure on the dose button during needle insertion.
Hold the dose button down until the dose counter returns to 0 after the injection.
Hold the dose button down until the dose counter shows 0.
Dose button.
Dose button with.
Dose button with 3 lines.
Dose button with smooth surface.
Press the dose button until the dose counter returns to 0.
Press the dose button until the dose counter returns to 0.
Press the dose button with your thumb until the dose counter returns to 0.
Press the dose button with your thumb until the dose counter returns to 0.