Examples of using Initial temperature in English and their translations into Greek
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Financial
-
Official/political
-
Computer
Initial temperature rise.
And there's the initial temperature.
Initial temperature: 80 degrees C.
This mixing temperature is somewhere between the two initial temperatures.
The initial temperature of the food.
But you will not see the Mpemba effect for just any initial temperatures, container shapes, or cooling conditions.
Initial temperature: 80 degrees C Min.
Within several hours after the restoration of the initial temperature in the room, tenants may return to it.
Initial temperature: 80 degree Celsius.
For every 10-20 seconds that the door is open,the fridge to operate for 45 minutes straight to get back to the initial temperature.
What's the initial temperature of the material.
Intramuscular and joint temperature changes depend on application method, initial temperature and application time.
The initial temperature of water in the pipes is 50° C at most.
Both superficial anddeep temperature changes depend on the method of application, initial temperature and application time.
An initial temperature of 60 degrees is recommended because the air is distributed relatively quickly.
A typical problem was to find how the temperature along a thin rod changes as time passes, given the initial temperature profile.
In a few hours after the initial temperature in the room is restored, the tenants may return to it.
A typical problem was to find how the temperature along a thin rod changes as time passes,given the initial temperature profile.
A deviation of initial temperature may also lead to a discrepancy in final temperature. .
The ambient temperature control system is then turned on(if not already on) and adjusted for an initial temperature of 308 oK(35 oC)[309 oK(36 oC)].
Some models have an initial temperature of 85 degrees, which means that the distribution takes a bit longer.
This can lead to colds and frustrate hardening schedule,then have to again go back to the initial temperature, and go through the process again.
Time in sec heat energy WJ initial temperature, T1 end temp, T2 temp difference mass heat capacity, c.
This means that the change in temperature of a water mass caused by adding a certain amount of heat to it will be a function of the water's initial temperature.
Where T0 is the initial temperature of the sphere and TS the temperature at the surface of the sphere, of radius L.
The only way to restore the system to its original state is to compress itto its initial volume, while transferring heat from the gas until it reaches its initial temperature.
If you know the heat capacities and initial temperatures of the stone and the water, and the final temperature of the water, you can quantify the entropy increase in calories or joules per degree.
Planetary scientists think that while the Earth and Venus are very similar,Venus' closer proximity to the sun gave that planet an initial temperature higher than that of the Earth that led to a runaway greenhouse effect.
On examining the initial temperature value, it was found that the surface temperature of the steam line was reduced from 160°C to 80°C when coated with coating of about 3mm thickness.
A BTU is the amount of heat required to raise the temperature of 1 avoirdupois pound of liquid water by 1 degree Fahrenheit at a constant pressure of one atmosphere.[1] As with the calorie, several definitions of the BTU exist, because the temperature response of water to heat energy is non-linear.This means that the change in temperature of a water mass caused by adding a certain amount of heat to it will be a function of the water's initial temperature.