Examples of using Test sample in English and their translations into Slovenian
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Financial
-
Computer
-
Official/political
-
Programming
Coupon to buy a test sample!
Put each test sample of 70( 5) grams into an Erlenmeyer flask which is then sealed with a stopper.
This strip is the laboratory test sample.
How often will test sample be tested? .
Procedure A: one determination per test sample.
Identification of Test Sample in Test Reports?
Procedure B: the result corresponds to the mean value of two determinations per test sample.
Factory inspection and test sample selection.
To obtain a laboratory test sample of x g, the strip area shall be x104/G cm2, where G is the mass of the cloth in g/m2.
Toxicology was here earlier ran a test sample, so no funny stuff.
This is not a vaccine, but a test sample that is capable of diagnosing the latent form of tuberculosis with maximum accuracy.
Install cable test hole, electricity test sample for test. .
To obtain a laboratory test sample of x g, the strip area shall be x104/G cm2.
An endurance test shall be performed on a test sample with the following test force:.
To obtain a laboratory test sample of x g, the strip area shall be x104/G cm2, where G is the mass of the cloth in g/m2.
Subject the laboratory test sample to the pre-treatment.
Where a test sample fails a particular test to which it has been subjected, a further test to the same requirements shall be carried out on at least three other samples. .
How often will test sample be tested? .
Subject the laboratory test sample to the pre-treatment and then cut the strip transversely into four equal lengths and superimpose them.
Take from the pre-treated laboratory test sample a specimen of mass not less than 1 g.
If glucose is included in a test sample, it reacts with the enzyme, initiates a short chain of reactions, and eventually creates an electrical signal.
Select from the pre-treatment laboratory test sample a specimen of mass not less than 1 g.
The current required for the test sample can be estimated by its capacitance, Is= Us w Cx, where Cx includes the test capacitor and additional capacitance.
Take from the pre-treated laboratory test sample a test specimen weighing at least 1 g.
Subject the laboratory test sample so formed to the pre-treatment.
After being subjected to the required number of thermal cycles, the test sample is held at a temperature of 20(±3)°C pending the execution of the detonability test. .
The test specimens are taken from the laboratory test sample in such a way that each of them is representative of the laboratory test sample. .