英語 での Initial position の使用例とその 日本語 への翻訳
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Programming
Start- initial position;
Push up: re-center the gimbal to the initial position.
Initial Position is Below Horizon.
Set a Canvas Initial Position.
The initial position is lying on the back.
Your Move ECG has been correctly reset andthe hands move to their initial position.
S” means the initial position of the player.
Then, using the same muscles again,press again to accept the initial position.
Specify the initial position of the Board.
Your Withings Move has been correctly reset andthe hands move to their initial position.
The initial position is lying on the abdomen.
This position is always the pointer's final position, not its initial position.
The initial position decision is very important.
In the de-energised condition the control spool(3)is held in the neutral or initial position by means of return.
In the initial position, the hands are located next to the body.
In the operating state, the control spool(3)is held in the neutral or initial position by the return spring(4).
Initial position, slightly ahead in the saddle, more pressure on perineum.
If a car comes back to its initial position, then the displacement is zero.
The initial position, the initial velocity, and the acceleration are set in the 31th, 32th, and 33th lines.
Z key: the machine from top to bottom in accordance with the Z route wipe,automatic wipe complete will back initial position.
To return to the initial position of the chart, double click in its central part.
LIB929701 Specification change In theentry field of the numeric type item, the initial position of the cursor is right-aligned.
To return the seats to its initial position will make the operation from inside the passenger compartment.
N key: the machine from left to right in accordance with the N route wope,automatic wipe complete will back initial position.
Manual or automatic operation, After the test,the moving iron return to initial position with the highest speed by manual or automatic operation.
N clean route: the machine from left to right in accordance with the N route wope,automatic wipe complete will back initial position.
In the de-energized condition thecontrol spool is held in the neutral or initial position by means of return springs(except for impulse spools).
Gauze straining roller processingView details RT The changes in initial position accuracy after printing begins is controlled(numerical control of small-sized frames by mechanization).
Return back Manual or automatic operation, After the test,the moving iron return to initial position with the highest speed by manual or automatic operation.