Examples of using Cold engine in English and their translations into Dutch
{-}
-
Colloquial
-
Official
-
Ecclesiastic
-
Medicine
-
Financial
-
Computer
-
Ecclesiastic
-
Official/political
-
Programming
You can't gun a cold engine.
A cold engine uses disproportionately more fuel.
Tip 1: How to start a cold engine.
The cold engine is also preheated by the device.
NB Always do this with a cold engine.
People also translate
What about if a cold engine is hard to start?
Use the choke to start a cold engine.
With a cold engine the engine runs a bit poorly;
The valves must be adjusted on a cold engine.
Cold engines produce more CO than hot engines. .
Should be replaced every 10 000 km, with cold engine.
This is another reason why cold engines are hard to start.
A cold engine uses more fuel than a warmed up engine. .
The gas slides stick sometimes on a cold engine and won't close.
A cold engine uses more fuel than a warm engine
Valve clearance inlet- and outlet valve, cold engine: 0,10 mm.
Using Revive Starting with a cold engine, unclip the intake trunking after the airfilter.
which has the same effect on the cold engine.
Choke Lever Before starting a cold engine, move the choke lever forward.
Software modification to make sure the vehicle starts better with a cold engine.
Correct warming up of the cold engine- an accessible reserve of economy of fuel.
Cold engines operate inefficiently,
the internal valve as follows with a cold engine and without a flame.
Difficulty in starting a cold engine is really a problem especially to those living in cold areas.
which is especially noticeable when the cold engine is started in winter.
Preparation for start-up and start-up of the cold engine- organizujushchee the beginning of economic
At start-up of the cold engine after long parking it is recommended to extend completely the handle of management air zaslonkoj,
that was fluid enough to work in a cold engine but sufficiently viscous to withstand extreme heat and friction.
Applications: Hot and cold engine test benches,
Directly going high revs or running full throttle with a cold engine might lead to excessive wear and/or damage of the piston and/or cylinder.