Examples of using Test object in English and their translations into Bulgarian
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Ecclesiastic
-
Computer
The test object is pure duranium.
Think of it as a test object.
(2) The test object and test equipment should be properly grounded.
Measures capacitive, resistive or inductive test objects.
(4) The surface of the test object should be clean and dry.
Processing method: check the output cable and check the test object.
If the test object has special functions, it should be specified in the test record.
It is to determine if the insulation of test object is good or not.
If the test object by the environmental electromagnetic interference is too large, resulting in instrument readings beating.
All functions anddesign requirements of the test object must be tested without missing items.
According to the test results, metal detector BLISSTOOL LTC48 is detect 21 of total 23 test objects(items).
If the setting value is too large, even if the test object discharges or the small current breaks down.
The case that no discharging rod is passed through butground lead is directly connected to the test object is prohibited.
This means that the test object will be grounded on both sides throughout the test giving a safer, faster and easier workflow.
That evening the prof. Karin's rocket 128 was setting off to the Moon… with a new test object aboard- a pussycat.
When choosing a test object, such a program will display in detail the volume of each file in percent, revealing volumetric data.
Games are the most unpretentious tests that can barely provide an opportunity to assess the degree of development of the test object.
Third, and then the discharge of a large capacitive test object should be 100Ω/ V discharge resistance of the test object discharge.
Critically, the test object still receives the Alternating Sinusoidal Voltage that would be supplied through everyday use, but the size of the test equipment is much smaller.
After the debugging object protection logic verification is completed,the corresponding switch should be tested for transmission according to the function of the test object.
Greatly reduces the detection stage to the operation of the actual test object, and can not only improve the detection efficiency, save the test resources but reduced Labor intensity.
The voltage, waveform, frequency of the AC withstand voltage test andthe distribution of the internal voltage of the insulation of the test object are in line with the actual operation.
Critically, the test object still receives the Alternating Sinusoidal Voltage that would be supplied through everyday use, but the size of the test equipment is much smaller.
If the setting value is too small, it may be in the boosting process,not the breakdown of the test object, but the electromagnetic switch is tripped due to the large current of the test. .
Bottom: a coin as a test object, a speckle image of the coin covered with non-transparent paint, an activity map showing the different vaporization rate on the coin surface after the binarization.
A Kibble balance orwatt balance is an electromechanical measuring instrument that measures the weight of a test object very precisely by the electric current and voltage needed to produce a compensating force.
For different test objects and different environmental conditions, the frequency selective amplifier can select different center frequencies(from tens of thousands of Hertz to hundreds of thousands of Hertz) to Get a large signal to noise ratio.
The amount of voltage, due to the effect of the rise in capacitance,the voltage actually applied to the test object exceeds the test voltage, causing the test piece to breakdown and misjudge as Failed.
Because of the high insulation and arc extinguishment of SF6 gas, its corona and local mass can be controlled in a small range, still can remain silent at the rated voltage,which can help to distinguish the discharge sound of the test object.
In case the cable is too short(less than 500 meters),the capacitance of the test object is smaller than 0.1μF and the pressure cannot be normally boosted, please connect 0.1μF high-voltage capacitance in parallel way.