Examples of using Test object in English and their translations into Norwegian
{-}
-
Colloquial
-
Ecclesiastic
-
Ecclesiastic
-
Computer
I, the test object and test requirements.
Unique Subsea Data Logger with manifold for filling of test object.
(4) The surface of the test object should be clean and dry.
G","E", and connect the"G" and"L" wires"G" and"E" wires at both ends of the test object.
If the test object has special functions, it should be specified in the test record.
It is to determine if the insulation of test object is good or not.
Note: The test object should be tested according to the pre-established test form.
All functions and design requirements of the test object must be tested without missing items.
During the test, 6 milliamp meters show the leakage current of each corresponding test object.
Thermocouples are placed all over the test object and connected to computers in the control room.
The case that no discharging rod is passed through butground lead is directly connected to the test object is prohibited.
If the setting value is too large, even if the test object discharges or the small current breaks down.
If the test object by the environmental electromagnetic interference is too large, resulting in instrument readings beating.
The resonant frequency depends on the capacitance of the test object and the inductance of the reactor.
When choosing a test object, such a program will display in detail the volume of each file in percent, revealing volumetric data.
Just use a multimeter to measure the outlet clamp or the test object to the core in the running panel.
We 2000MB length of the file as a test object, USB3.0 interface in the read speed relative to the eSATA interface slightly prevail.
Nevertheless, it is necessary to specify in each test procedure what type of test object it is appropriate to verify.
Protection: the test object has over-current, over-voltage and flashover protection test(see the frequency conversion power supply section).
Note: For the transmission test of the switch in the exit and operation of the test object, the switch must not be actually carried out.
For tightness tests at regular doors and fire doors or windows the ultrasonic transmitter SL800T can simply be installed behind the test object.
Third, and then the discharge of a large capacitive test object should be 100Ω/ V discharge resistance of the test object discharge.
The test instrument is connected correctly, and the connection between the high-voltage output part and the test object should be reliable.
For the test object with the wheel jump function, all rounds of motion should be simulated, and each round has the opportunity to actually drive the switch.
There should be a clear cut-off point in the working power supply,which should be cut off clearly in case of replacement of test object and wiring.
In order toobtain optimum results, the distance between test object and sensor head- depending on the degree of charge and the condition of the objects' surface- can be selected incrementally.
If the surface is flashed anddischarged due to the humidity of the air or the surface of the test object, it should not be regarded as unqualified.
The length of the protective resistor is selected such that when the test object breaks down or flashover, the protective resistor shall not flash along the surface and its length shall be capable of withstanding the maximum test voltage with adequate margin.
The table provides an overview of the test procedures and the topic being tested, including an overview of the test object in each test procedure.
The long structure-borne sound probe with stainless steel tip(4)available as an accessory can be directly placed on the test object and enables fast inspections in order to prevent damage on rotating machine components without disturbing the ongoing operation.