Examples of using Test object in English and their translations into Swedish
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Ecclesiastic
-
Official/political
-
Computer
-
Programming
-
Political
The test object is pure duranium.
Make it possible for an applet to offer a test object.
The test object is made of pure duranium.
It is to determine if the insulation of test object is good or not.
The test object was sent a few minutes into the future.
G","E", and connect the"G" and"L" wires"G" and"E" wires at both ends of the test object.
The test object and test equipment should be properly grounded.
During the test, 6 milliamp meters show the leakage current of each corresponding test object.
Depending on the test object, the humidity can amount to values between 10 and 95 per cent.
The operator or the system controller is then informed by the detector about the total leakage from the test object.
Test object maximum height one third of distance between cell floor and septum.
If the setting value is too large, even if the test object discharges or the small current breaks down.
Note: The test object should be tested according to the pre-established test form.
Just use a multimeter to measure the outlet clamp or the test object to the core in the running panel.
The insulation damage is small, and the DC high-voltage generator has less damage to the insulation of the test object.
With this testing method, the test object is coated with a solution that contains a visible
the connection between the high-voltage output part and the test object should be reliable.
If the test object by the environmental electromagnetic interference is too large,
which should be cut off clearly in case of replacement of test object and wiring.
When choosing a test object, such a program will display in detail the volume of each file in percent,
thereby deformations to the test object within a margin of error by 5 percent.
Protection: the test object has over-current,
The rest are fitted to the test bed gears controlling the speed of the test object, as well as in the load unit's shaft connection which simulates the wind.
For the test object with the wheel jump function,
Third, and then the discharge of a large capacitive test object should be 100Ω/ V discharge resistance of the test object discharge.
the distribution of the internal voltage of the insulation of the test object are in line with the actual operation.
The aged and cooled test object showed less strength
If the setting value of the overcurrent relay is appropriate, the overcurrent relay should be operated when the test object breaks down, and the electromagnetic switch will follow with the electromagnetic switch.
ground lead is directly connected to the test object is prohibited.
When there is no discharge sound, the top tip of the discharging rod can be used to contact the test object for discharging, and finally the ground lead is connected directly to the test object.