Examples of using Test object in English and their translations into Portuguese
{-}
-
Colloquial
-
Official
-
Medicine
-
Financial
-
Ecclesiastic
-
Ecclesiastic
-
Computer
-
Official/political
Test object that will be checked.
Flaws or cracks in the test object.
Test object for life waves.
Capacitance range of test object.
The surface of the test object should be clean and dry.
Signals for control of test system and test object.
You want to change test object without proceeding with it until the end?
It is to determine if the insulation of test object is good or not.
The test object and test equipment should be properly grounded.
AssertTrue() because the test method is invoked on a test object.
If the test object has special functions, it should be specified in the test record.
Processing method: check the output cable and check the test object.
All functions anddesign requirements of the test object must be tested without missing items.
G","E", and connect the"G" and"L" wires"G" and"E" wires at both ends of the test object.
The resonant frequency depends on the capacitance of the test object and the inductance of the reactor.
Note: The test object should be tested according to the pre-established test form.
The solder terminals are installed in the same way on the test object as on the strain gauge.
If the test object by the environmental electromagnetic interference is too large, resulting in instrument readings beating.
After disconnecting the insulation resistance meter,discharge the test object to ground.
If the setting value is too large, even if the test object discharges or the small current breaks down.
On the other hand, the entire teams can access the data simultaneously andjointly work on a test object.
Just use a multimeter to measure the outlet clamp or the test object to the core in the running panel.
During the test, 6 milliamp meters show the leakage current of each corresponding test object.
The high current test system measures the temperature of the test object at various points, in addition to the current.
The insulation damage is small, andthe DC high-voltage generator has less damage to the insulation of the test object.
When this device is connected to a test object, it may exceed the emission levels produced by CISPR 11 requirements. Korea KCC.
Emissions that exceed the levels required by CISPR 11 can occur when the equipment is connected to a test object.
After each result,the robot then places the test object back on the pallet and rejects it if the dimensions are not to spec.
The fact that the assertion methods are declared static allows for(re)using them outside the scope of a test object.
If the HV reactor and test object are designed to form a series resonant circuit, the result will be an ideal sinusoidal testing voltage.